Have an account?
Skip to Content
Introducing new Paper mode
No student devices needed. Know more
18 questions
Show Answers
See Preview
- Multiple ChoicePlease save your changes before editing any questions.
The safest way to remove scrap pieces from around the revolving blade is to:
Turn off the power and wait for the blade to stop.
Use a push stick
Remove the stock being cut first,, before removing the chips
Both A and B
- Multiple ChoicePlease save your changes before editing any questions.
When crosscutting boards to a desired length on the tablesaw, a safe method to use is:
The fence alone as a guide
The first piece cut as a gauge
A stop block clamped to the side of the fence as a guide
Any of the above
- Multiple ChoicePlease save your changes before editing any questions.
When operating a table saw, you should stand:
To the right side of the blade if possible
To the left side of the blade.
Directly in line with the blade.
Not in direct line of the blade.
- Multiple ChoicePlease save your changes before editing any questions.Crosscutting of stock normally requires a:FencePush StickStop BlockMiter Gauge/Cross cut sled
- Multiple ChoicePlease save your changes before editing any questions.
When is it safe to do freehand (no fence, no miter gauge) sawing on the table saw?
When cutting circles
When cutting very thin stock
Never
When cutting plywood
- Multiple ChoicePlease save your changes before editing any questions.Is it safe to rip stock with the splitter in place?TrueFalse
- Multiple ChoicePlease save your changes before editing any questions.Is it safe to saw defective stock(warps and any foreign material?TrueFalse
- Multiple ChoicePlease save your changes before editing any questions.
Which type of stock should never be ripped on the table saw
Square stock
Thick Stock
Round Stock
Flat Stock
- Multiple ChoicePlease save your changes before editing any questions.All table saw adjustments should be made:While the saw is in motionWhile the saw is completely stopped.It depends on which type of blade you're using.After the fence has been removed from the table.
- Multiple ChoicePlease save your changes before editing any questions.
Crosscutting a Board to length is done with the
Fence
Sliding Miter Gauge
Tape Measure
Sliding Miter Gauge and Stop Block
- Multiple ChoicePlease save your changes before editing any questions.Do not use a ________ blade.dullsharpcombinationdado
- Multiple ChoicePlease save your changes before editing any questions.Do not use both the rip fence and the _________ at the same time while cutting stock.dado headguardpush stickmiter gauge
- Multiple ChoicePlease save your changes before editing any questions.Use a push stick when ripping material less than ________.4" wide12" wide1" widethe fence height
- Multiple ChoicePlease save your changes before editing any questions.
Identify Part A
Blade Guard
Table
Miter Guage
Elevation Hand Wheel
- Multiple ChoicePlease save your changes before editing any questions.
Identify Part B
Miter Gauge
Power Switch
Blade Guard
Table
- Multiple ChoicePlease save your changes before editing any questions.
Identify Part C
Fence
Tilt Hand Wheel
Miter Gauge
Blade Guard
- Multiple ChoicePlease save your changes before editing any questions.
Identify Part D
Blade Guard
Power Switch
Fence
Miter Gauge
- Multiple ChoicePlease save your changes before editing any questions.
Identify Part E
Elevation Hand Wheel
Tilt Hand Wheel
Power Switch
Miter Gauge