Have an account?
Skip to Content
Build your own quiz
40 questions
Show Answers
See Preview
- 1. Multiple ChoiceA vehicle has a steady pull to the left. All of these will cause this condition EXCEPT:The caster angle.Low tire pressure.The camber angle.Steering U-joint coupling.
- 2. Multiple ChoiceTechnician A says a vehicle will pull to the side with the most positive camber. Technician B says that too much negative camber will result in excessive wear on the inside tread of the tire. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 3. Multiple ChoiceTwo technicians are discussing inner and outer tie rods. Technician A says to turn the outer tie rod end to adjust the toe. Technician B says loose inner tie rod ends will cause a tire to feather. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 4. Multiple ChoiceThe rear tires on a vehicle with independent rear suspension are worn on the inside tread. Which of the following is MOST likely the cause of this condition?The toe.Underinflated tires.The caster.None of the above.
- 5. Multiple ChoiceTechnician A says SAI or Steering Angle Inclination is adjusted by changing the caster angle. Technician B says camber adjustments are included in the Included Angle. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 6. Multiple ChoiceOn cold mornings, the warning lamp on a vehicle with a TPMS tire pressure monitoring system stays illuminated for several minutes before it goes out. Which of these is MOST likely the cause of this condition.Clogged TPMS sensor.Worn tread on one of the tires.TPMS initialization.Low tire pressure.
- 7. Multiple ChoiceA front wheel drive vehicle is pulling to the left. Loose engine cradle bolts are noticed during the initial inspection. Technician A says loose engine cradle bolts will cause a vibration, but have no affect on the vehicle's steering system. Technician B says if the engine cradle is not centered before fastening the bolts, the wheel alignment angles will be affected. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 8. Multiple ChoiceTwo technicians are discussing an electronic air suspension system. Technician A says the suspension switch must be turned off before lifting the vehicle. Technician B says to use soapy water to visually inspect this system for leaks. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 9. Multiple ChoiceLoose tie rods are discovered during the initial inspection of a vehicle's steering linkage. Technician A says loose tie rods will cause a clunking or popping noise while turning. Technician B says loose tie rods will result in constant steering correction and vehicle wander. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 10. Multiple ChoiceTechnician A says a directional tire must be kept on the same side of the vehicle during a tire rotation. Technician B says tire inflation pressure is considered cold as long as the vehicle has been driven less than ten miles. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 11. Multiple ChoiceTechnician A says two different size tires on the rear of a vehicle will illuminate the amber ABS light. Technician B says the 60 in P225/60R16 89H indicates the tire's section width. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 12. Multiple ChoiceA front wheel drive vehicle with a rack and pinion power steering system is being diagnosed. During the test drive, the technician notices the steering is binding in one spot, only while turning right. Which of these is the MOST likely cause of this condition?The rack and pinion gear.The universal joint coupling.Loose tie rods.The steering knuckle.
- 13. Multiple ChoiceA vehicle's right front wheel is making a growling noise that increases with vehicle speed. All of these will result in this condition EXCEPT:Excessive caster.Cupped tire tread.Worn strutsWorn wheel bearing.
- 14. Multiple ChoiceTwo technicians are performing a power steering pressure test. Technician A says a restriction in the high pressure line results in higher than normal test results. Technician B says if the pressure increases when the shutoff valve is closed, there's a problem with the power steering pump. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 15. Multiple ChoiceTwo technicians are discussing a recirculating ball steering gear. Technician A says to measure worm bearing preload with a foot pound torque wrench. Technician B says an under adjusted sector shaft will result in excessive steering wheel free play. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 16. Multiple Choice
Technician A says the vehicle in the chart above is within specifications. Technician B says the vehicle's front toe is out of specifications. Tire wear will result from this condition. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B - 17. Multiple ChoiceA vehicle with variable assist steering feels loose only at highway speeds. Technician A says to inspect VSS vehicle speed sensor operation. Technician B says this is caused by reduced pressure to the steering gear. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 18. Multiple ChoiceA vehicle with a ribbed serpentine belt makes a chirping noise when starting. Technician A says to check the belt with a belt wear gauge. Technician B says proper belt deflection is 1/2 inch per foot of belt span. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 19. Multiple ChoiceA vehicle has excessive body sway while cornering. Which of the following is MOST likely causing this condition.A binding ball joint.A worn idler arm.Worn control arm bushings.Worn stabilizer bar bushings.
- 20. Multiple ChoiceAfter replacing a tapered ball joint the technician loosens the castle nut just enough to install the cotter pin. Technician A says this procedure keeps the ball joint from binding. Technician B says a binding ball joint will result in memory steer. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 21. Multiple ChoiceTechnician A says that loose power steering rack bushings result in vehicle wander. Technician B says worn rack bushings cause changes in toe. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 22. Multiple ChoiceTwo technicians are discussing the toe setting of a front wheel drive vehicle with four wheel independent suspension. The right rear wheel is 1.5 degrees toe-in from specifications. Technician A says to set the front toe on this vehicle before correcting the rear. Technician B says the right rear wheels toe setting is 1.5 degrees positive (+). Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 23. Multiple ChoiceThere is noticeable wear on the left front tire of a rear wheel drive vehicle. The technician suspects the camber angle is out of specification. All these characteristics of camber are true EXCEPT:Negative camber causes wear on the tires inside tread.An out of specification camber angle will result in a steering pull condition.The vehicle will pull to the side with the most positive camber.Camber is not included in the included angle.
- 24. Multiple ChoiceTechnician A says a vehicle with torsion bar suspension can be adjusted to repair ride height. Technician B says on some vehicles, torsion bars are used in place of coil springs. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 25. Multiple ChoiceA vehicle feels bouncy and is oscillating at highway speeds. The vehicle's shock absorbers may be faulty. Technician A says it is acceptable for a slight film to appear on the shock absorber's shaft. Technician B says a small drip of oil appearing from the shock absorber's chamber is acceptable. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 26. Multiple ChoiceA vehicle with a power rack and pinion steering system is binding during turns. Which of the following is LEAST likely to cause this condition.Strut mount bearing.Worn rack bushings.Worn rack and pinion gear.Lower ball joint.
- 27. Multiple ChoiceTwo technicians are discussing excessive wear on the inside tread of a tire. Technician A says an out of specification caster angle will cause this type of wear. Technician B says an out of specification camber angle will cause this type of wear. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 28. Multiple ChoiceAfter installing a power steering gear, the vehicle's air bag light is illuminated. Technician A says the vehicle's wheel alignment needs to be adjusted to repair this light. Technician B says the clockspring has been damaged. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 29. Multiple ChoiceA vehicle pulls to the right and makes a clunking sound when the brakes are applied. During an alignment check the technician notices excessive negative caster on the right front wheel. Technician A says this is most likely caused by a seized brake caliper. Technician B says this is most likely caused by worn or missing strut rod bushings. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 30. Multiple ChoiceThe vehicle in the alignment chart pulls to the right. Technician A says this is because a vehicle will pull to the side with the most camber. Technician B says this is because the vehicle's caster angle is out of specifications. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 31. Multiple ChoiceDuring the visual inspection of a light truck, the technician notices the left rear leaf spring has a broken center bolt. Technician A says this will affect the vehicle's thrust angle. Technician B says an incorrect thrust angle will affect the centering of the steering wheel. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 32. Multiple ChoiceA technician is unable to balance a tire and has added weights in several places around the rim. Technician A says to continue adding weights up to 10 ounces. Technician B says to dismount the tire from the rim and inspect the inside for liquid or debris. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 33. Multiple ChoiceThe left front tire of a vehicle is feathered across its tread. What is the MOST likely cause of this condition?The caster setting.The toe setting.Worn struts.The camber setting.
- 34. Multiple ChoiceTechnician A says that a variable rate coil spring has varying spaces between the coils. Technician B says if a vehicle has a noticeable difference in height between sides, it may have a weak strut insert. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 35. Multiple ChoiceTechnician A says the power steering pressure switch sends a signal to the PCM to increase idle speed while parking. Technician B says variable assist steering provides maximum pressure during high speed operation. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 36. Multiple ChoiceThe vehicle in the alignment chart above has excessive shimmy above 45 mph. The MOST likely cause of this condition is:Camber.Wheel Balance.Toe.Caster.
- 37. Multiple ChoiceA vehicle with a power rack and pinion steering system doesn't return to center after completing a turn. Technician A says an incorrect caster angle will cause this condition. Technician B says a binding lower ball joint would have no affect on steering wheel return to center. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 38. Multiple ChoiceThe LEAST likely to result in memory steer is a binding:Ball joint.Steering gear.Upper strut mount.Wheel bearing.
- 39. Multiple ChoiceTwo technicians are discussing struts on a front wheel drive vehicle. Technician A says some struts have a camber lobe adjustment. Technician B says a worn strut tower will make excessive noise when going over bumps. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- 40. Multiple ChoiceTechnician A says a worn idler arm has no affect on a vehicle's total toe setting. Technician B says the center link is used in parallelogram linkage systems. Who is correct?Technician A onlyTechnician B onlyBoth Technician A and BNeither Technician A nor B
- Answer choicesTagsAnswer choicesTags